Inflatable balloon 50 cm
Inflatable cylinders for inflatable boats, 50 cm in diameter, made of German PVC fabric, are designed to build a large catamaran or trimaran, which will be used on large rivers, reservoirs or at sea. The hydrodynamics of this cylinder can be considered a reference for this diameter. From the nose of the balloon to the diameter of 50 cm - a very smooth lift, length of 120 cm. Therefore, we recommend that the top platform is located no closer than 120 cm from the nose of the balloon and at least 80 cm from the end of the balloon. This will allow you to properly distribute the load and maintain good germination on the wave and excellent driving performance. The rear part of the inflatable balloon is made in such a way that when the acceleration is overclocked, the catamaran keeps its level position in the water, without lifting its nose or lowering the stern. In the bow, the balloons of the Bothouse are equipped with an editorial, protected by PVC cloth. The entire lower part of the cylinders has additional protection, and in the rear part of the stabilizer stabilizes the stability. It is necessary to pay attention to additional equipment, which will greatly facilitate the construction of the catamaran and increase comfort and safety.
BOATHOUSE inflatable balloons for catamarans, inflatable boats, and kayaks are made from one-piece high-quality PVC fabric made in Germany with a density of 750 and 900. This is a rather complicated and costly method, especially when making large cylinders with a length of 6-8 meters. But thanks to this technology, the cylinder has only one seam, which is located below and is the strongest part, because it has triple fabric (two safety tapes are used - on the top and bottom of the seam). It is almost impossible to break through the balloon in this place (from the bottom of the balloon), taking into account the additional protection of the entire lower part of the cylinders over triple fabric.
The configuration of the cylinders can be "nose-to-nose" or conventional asymmetric. Nose-nose cylinders can be used to build a catamaran for mountain rivers, where directional stability is not important, and most importantly, good germination on the wave and passability, both front and back. The usual asymmetric form of cylinders is used to build catamarans and trimarans with good directional stability. But the most important thing is that all BOTHAUS cylinders can be considered standard in terms of hydrodynamic indicators - a small angle of attack on water, minimal resistance and excellent germination per wave.
All cylinders are identical to commercially available models that have different diameters - 32 cm, 38 cm, 42 cm, 45 cm, 50 cm, 55 cm, 60 cm and 65 cm. Thus, 8 types of inflatable balloons in two configurations can be made of any length (from 3 m to 9 m) and with any additional. equipment that will greatly facilitate the task of construction, will create additional amenities and a beautiful appearance.
Therefore, using BOTHAUS inflatable balloons to build your catamaran or trimaran, you provide your future vessel with excellent technical and operational characteristics, increased safety and reliability. What configuration, what diameter of cylinders and what length is more suitable for you - you will determine this by analyzing the information on our website on a model of a boat with the same diameter of cylinders. If questions arise, our experts will help you make the appropriate calculations.
Good prices, excellent quality, the correct configuration, and most importantly - excellent hydrodynamic performance - the foundation of any catamaran, will allow you to build a very good boat with excellent speed and driving characteristics.
"Having BOATHOUSE - you live with pleasure."
- This product has a minimum quantity of 2