Cylinder inflatable asymmetric 38 cm
Cylinders inflatable asymmetric, with a diameter of 38 cm have excellent hydrodynamics and, thanks to the understated rear part, good exchange rate stability. For an even better rate of stability, the editor is used in the bow of the balloon and the stabilizer of the stability in the rear. Inflatable cylinders for the catamaran already in the basic configuration have additional protection of the lower part along the entire length of the balloon. Cylinders are made of high-quality German PVC fabric, density 750. It should be noted that the strength of PVC fabric is attached to the inner court of fiberglass. So, on the gap of the fabric, the figures of 750 PVC fabric and 1100 PVC fabric are the same.
Inflatable balloon for boats The boathouse - hydrodynamics involves the construction of a light, fast and economical catamaran or a trimaran. Calculation of the carrying capacity can be carried out by analogy with the mass-produced models of the BOTHOUT - transports kayaks SPORTS, in which the same balloon is used. For better germination on the wave, the top platform should be located at a distance of 110 cm from the nose and 90 cm from the end of the cylinders. Pay special attention to the proposed additional equipment. It will allow you to design a unique, safe, economical and high-speed vessel. A distinctive feature of Bottle Cylinders is excellent hydrodynamic performance, and this is the basis of the basics of any boat.
BOATHOUSE inflatable balloons for catamarans, inflatable boats, and kayaks are made from one-piece high-quality PVC fabric made in Germany with a density of 750 and 900. This is a rather complicated and costly method, especially when making large cylinders with a length of 6-8 meters. But thanks to this technology, the cylinder has only one seam, which is located below and is the strongest part, because it has triple fabric (two safety tapes are used - on the top and bottom of the seam). It is almost impossible to break through the balloon in this place (from the bottom of the balloon), taking into account the additional protection of the entire lower part of the cylinders over triple fabric.
The configuration of the cylinders can be "nose-to-nose" or conventional asymmetric. Nose-nose cylinders can be used to build a catamaran for mountain rivers, where directional stability is not important, and most importantly, good germination on the wave and passability, both front and back. The usual asymmetric form of cylinders is used to build catamarans and trimarans with good directional stability. But the most important thing is that all BOTHAUS cylinders can be considered standard in terms of hydrodynamic indicators - a small angle of attack on water, minimal resistance and excellent germination per wave.
All cylinders are identical to commercially available models that have different diameters - 32 cm, 38 cm, 42 cm, 45 cm, 50 cm, 55 cm, 60 cm and 65 cm. Thus, 8 types of inflatable balloons in two configurations can be made of any length (from 3 m to 9 m) and with any additional. equipment that will greatly facilitate the task of construction, will create additional amenities and a beautiful appearance.
Therefore, using BOTHAUS inflatable balloons to build your catamaran or trimaran, you provide your future vessel with excellent technical and operational characteristics, increased safety and reliability. What configuration, what diameter of cylinders and what length is more suitable for you - you will determine this by analyzing the information on our website on a model of a boat with the same diameter of cylinders. If questions arise, our experts will help you make the appropriate calculations.
Good prices, excellent quality, the correct configuration, and most importantly - excellent hydrodynamic performance - the foundation of any catamaran, will allow you to build a very good boat with excellent speed and driving characteristics.
"Having BOATHOUSE - you live with pleasure."
- This product has a minimum quantity of 2